Figure 261: Installing A Rear Card In A Qfx3008-I Interconnect Device - Juniper QFabric QFX3000-G Hardware Documentation

Related
Documentation
Copyright © 2018, Juniper Networks, Inc.
root@qfabric>
From the QFabric director, enter the following configuration mode CLI commands to
9.
remove the previous rear card from the inventory of QFabric system components and
associate the serial number of the new rear card with the alias of the previous card.
root@fabric# delete fabric aliases interconnect-devices
old-serial-numberalias-name
root@fabric# set fabric aliases interconnect-devices new-serial-numberalias-name
Commit the changes using the
10.
the old device to the new device.

Figure 261: Installing a Rear Card in a QFX3008-I Interconnect Device

Rear Cards in a QFX3008-I Interconnect Device on page 55
Rear Card LEDs on a QFX3008-I Interconnect Device on page 733
Chapter 41: Replacing QFX3008-I Components
command, which sends the configuration of
commit
643