Figure 214: Qfx3100 Director Group Control Plane Connections For Qfx3000-Gqfabric System Using Copper-Based Control Plane - Juniper QFabric QFX3000-G Hardware Documentation

Hide thumbs Also See for QFabric QFX3000-G:

Table of Contents

QFX3000-G QFabric System Hardware Documentation

Documentation

Connecting QFX3100 Director Devices in a Director Group

through Step

assignments in

Table 141 on page

Secure the cables so that they are not supporting their own weight. Place excess cable

out of the way in a neatly coiled loop. Placing fasteners on a loop helps cables maintain

their shape.

Do not bend fiber-optic cables beyond their minimum bend

radius. An arc smaller than a few inches in diameter can damage the cables

and cause problems that are difficult to diagnose.

Do not let fiber-optic cables hang free from the connector. Do not allow

fastened loops of cables to dangle, which stresses the cables at the

fastening point.

Installing and Connecting a QFX3100 Director Device on page 377

A QFabric system requires two QFX3100 Director devices interconnected as a QFX3100

Director group (see

Figure 214 on page 500

Figure 214: QFX3100 Director Group Control Plane Connections for QFX3000-G QFabric

System Using Copper-Based Control Plane

for each uplink module port, following the port

Figure 216 on page

Chapters

Table of Contents