Juniper QFabric QFX3000-G Hardware Documentation page 932

QFX3000-G QFabric System Hardware Documentation
Packing a QFX3100 Director Device for Shipping
882
Retrieved the original shipping carton and packing materials. Contact your JTAC
representative if you do not have these materials, to learn about approved packing
materials. See "Contacting Customer Support to Obtain a Return Materials Authorization
for a QFX Series Device or Component" on page
Ensure that you have the following parts and tools available:
Antistatic bag, one for each component
Electrostatic discharge (ESD) grounding strap
Phillips (+) screwdriver, number 2
Packing a QFX3100 Director Device for Shipping on page 882
Packing QFX3100 Director Device Components for Shipping on page 883
To pack a QFX3100 Director device for shipping:
Attach the grounding strap to your bare wrist and to a site ESD point.
1.
Power down the device. See
2.
Disconnect power from the device by performing one of the following:
3.
If the power source outlet has a power switch, set it to the OFF (O) position.
If the power source outlet does not have a power switch, gently pull out the male
end of the power cord connected to the power source outlet.
Remove the cables that connect the device to all external devices.
4.
Have one person support the weight of the device while another person unscrews and
5.
removes the mounting screws. Use the Phillips (+) screwdriver, number 2 to remove
the screws.
Remove the device from the rack or cabinet (see
6.
QFX3100 Director Device" on page
Place the device in the shipping carton.
7.
Place the packing foam on top of and around the device.
8.
If you are returning accessories or FRUs with the device, pack them as instructed in
9.
"Packing QFX3100 Director Device Components for Shipping" on page
Replace the accessory box on top of the packing foam.
10.
895.
"Powering Off a QFX3100 Director Device" on page
"Chassis Lifting Guidelines for a
338) and place the device in an antistatic bag.
Copyright © 2018, Juniper Networks, Inc.
559.
883.