Juniper QFabric QFX3000-G Hardware Documentation page 436

QFX3000-G QFabric System Hardware Documentation
Related
Documentation
Connecting a QFX Series Device to a Management Console
386
Switch on the site circuit breakers.
3.
Press the power switch on the rear panel of the QFX3100 Director device to power on
4.
the device.
NOTE: Pressing the power switch momentarily either causes the system
to power on or causes a graceful shutdown. Pressing the power switch
for 4 seconds or longer causes an abrupt power shutdown.
Observe the power supply faceplate LEDs. If the power supply is installed correctly
5.
and functioning normally, the AC power supply LED is green.
On the external management device, monitor the startup process to ensure that the
6.
system boots properly.
NOTE: After you power on a power supply, wait for at least 60 seconds before
you turn it off. After you power off a power supply, wait for at least 60 seconds
before you turn it back on.
Powering Off a QFX3100 Director Device on page 559
AC Power Supply in a QFX3100 Director Device on page 34
AC Power Cord Specifications for a QFX3100 Director Device on page 277
The QFX Series has a console port with an RJ-45 connector. Use the console port to
connect the device to a management console or to a console server.
Ensure that you have an RJ-45 to DB-9 rollover cable available. An RJ-45 cable with an
RJ-45 to DB-9 adapter is provided with the device.
NOTE: If your laptop or PC does not have a DB-9 male connector pin and you
want to connect your laptop or PC directly to the QFX Series, use a
combination of the RJ-45 cable and RJ-45 to DB-9 adapter supplied with the
device and a USB to DB-9 male adapter. You must provide the USB to DB-9
male adapter.
To connect the QFX Series to a management console (see
Figure 152 on page 387):
Connect one end of the Ethernet cable to the console port (labeled
1.
Figure 151 on page 387
CON ).
Copyright © 2018, Juniper Networks, Inc.
and