Figure 219: Qfx5100 Node Device Control Plane Connections - Juniper QFabric QFX3000-G Hardware Documentation

QFX3000-G QFabric System Hardware Documentation
Related
Documentation
Connecting a QFX5100 Node Device to a Copper-Based QFX3000-G QFabric System
Control Plane Network
510
Connect the other end of that cable to port
h.
Connecting a QFX3500 Node Device to a Copper-Based QFX3000-G QFabric System
Control Plane Network on page 515
Connecting a QFX3500 Node Device to a QFX3008-I Interconnect Device on page 548
Connecting QFX3100 Director Devices to a Copper-Based QFX3000-G QFabric System
Control Plane Network on page 502
Connecting QFX3100 Director Devices in a Director Group on page 500
A QFX3000-G QFabric system control plane and management network is formed by
connecting the QFX series devices in your network to two Virtual Chassis composed of
four EX4200 or four EX4300 switches. If you are creating a copper-based control plane
network, you use the four EX Series Ethernet switches in each Virtual Chassis.
QFX5100-48S Node devices have an RJ-45
cage that can be used as a copper management port. Use the RJ-45 management
C1
port (labeled and the SFP management port
C0
to each Virtual Chassis. See

Figure 219: QFX5100 Node Device Control Plane Connections

Use the following QFX5100 Node devices and EX4200 switches for a copper-based
QFX3000-M QFabric system control plane network:
QFX5100 Node devices with:
em0–RJ-45 (1000BASE-T) management Ethernet port (
em1–SFP management Ethernet port (
Virtual Chassis of EX4200-48T or EX4300-48T switches with SFP+ uplink modules
installed.
Before you begin to connect a QFX5100 Node device to the QFX3000-G QFabric system
control plane network:
ge-3/0/38
C0 located under the
) to connect the QFX5100 Node device
C1
Figure 219 on page 510 for a cabling example.
EX Series EX Series
) cage (socket for 1 GbE copper SFP)
C1
on the second Virtual Chassis.
CON port, and an SFP
C0 )
Copyright © 2018, Juniper Networks, Inc.