Figure 251: Installing A Bottom Air Filter In A Qfx3008-I Interconnect Device - Juniper QFabric QFX3000-G Hardware Documentation

Related
Documentation
Removing a Side Air Filter from a QFX3008-I Interconnect Device
Copyright © 2018, Juniper Networks, Inc.

Figure 251: Installing a Bottom Air Filter in a QFX3008-I Interconnect Device

Cooling System and Airflow in a QFX3008-I Interconnect Device on page 48
Removing a Bottom Air Filter from a QFX3008-I Interconnect Device on page 620
Maintaining the Air Filters in a QFX3008-I Interconnect Device on page 719
The QFX3008-I Interconnect device has eight side air filters located in each of eight side
fan tray modules. A tab on the air filter facilitates the removal and installation of the air
filter.
CAUTION: Do not run the device for more than 2 minutes without the air filter
in place.
CAUTION: Always keep the air filter in place while the device is operating,
except during replacement. Because the fans are very powerful, they could
pull small bits of wire or other materials into the device through the unfiltered
air intake. This could damage device components.
Before you remove a side air filter, ensure that you understand how to prevent ESD
damage. See "Prevention of Electrostatic Discharge Damage" on page
Ensure that you have the following parts and tools available to remove a side air filter
from a QFX3008-I Interconnect device:
Electrostatic discharge (ESD) grounding strap
Replacement air filter
Chapter 41: Replacing QFX3008-I Components
360.
623