Figure 305: Installing An Uplink Module In An Ex4200 Switch - Juniper QFabric QFX3000-G Hardware Documentation

Hide thumbs Also See for QFabric QFX3000-G:

Table of Contents

Documentation

Removing a Fan Tray from an EX4200 Switch

Figure 305: Installing an Uplink Module in an EX4200 Switch

If you have a Juniper J-Care service contract, register any addition,

change, or upgrade of hardware components at

https://www.juniper.net/customers/support/tools/updateinstallbase/

to do so can result in significant delays if you need replacement parts. This

note does not apply if you replace existing components with the same type

of component.

Troubleshooting Virtual Chassis Port Connectivity on an EX4200 Switch

Removing an Uplink Module from an EX4200 Switch on page 699

Installing a Transceiver

Installing and Removing EX4200 Switch Hardware Components

Configuring Gigabit Ethernet Interfaces (CLI Procedure)

Front Panel of an EX4200 Switch

The fan tray in an EX4200 switch is a hot-removable and hot-insertable field-replaceable

unit (FRU) located on the rear panel of the switch: You can remove and replace it without

powering off the switch or disrupting switch functions.

Ensure that you have the following parts and tools available:

Phillips (+) screwdriver, number 2

An antistatic bag or an antistatic mat

Chapter 46: Replacing EX4200 Components

Table of Contents