Figure 361: Leds On The Uplink Module Ports On The Sfp+ And Sfp+ Macsec; Uplink Modules; Figure 362: Leds On The Uplink Module Ports On The Xfp Uplink Module; Table 224: Link/Activity Led On Network Ports - Juniper QFabric QFX3000-G Hardware Documentation

QFX3000-G QFabric System Hardware Documentation

Table 224: Link/Activity LED on Network Ports

LED
Link/Activity
810
Figure 361: LEDs on the Uplink Module Ports on the SFP+ and SFP+ MACsec Uplink
Modules

Figure 362: LEDs on the Uplink Module Ports on the XFP Uplink Module

Port 0
The LEDs labeled Link/Activity LED in
Figure 361 on page 810, and
Status LED in Figure 359 on page
Figure 362 on page 810 indicate the status of one of the four port parameters. The port
parameters are administrative status, duplex mode, Power over Ethernet (PoE) status,
and speed.
Table 224 on page 810 describes the Link/Activity LED.
Color
Green
Status LED Status LED
Port 1
Link/Activity Link/Activity
LED LED
Figure 359 on page
Figure 362 on page 810 indicate link activity. The LEDs labeled
809, Figure 360 on page
State and Description
Blinking—The port and the link are active, and there is link
activity.
On steadily—The port and the link are active, but there is no
link activity.
Off—The port is not active.
809, Figure 360 on page
809, Figure 361 on page 810, and
Copyright © 2018, Juniper Networks, Inc.
809,