Juniper QFabric QFX3000-G Hardware Documentation page 603

Copyright © 2018, Juniper Networks, Inc.
Please enter the Director Group 0 IP address and prefix: ip address/prefix
Please enter the Director Group 1 IP address and prefix: ip address/prefix
Please enter the Director Group Subnet Mask: subnet mask
Enter the gateway IP address for the Director group.
5.
Please enter the Director Group gateway IP address: gateway ip address
Enter the default partition IP address. (You will use this address to log in to the QFabric
6.
system on subsequent connections.)
Please enter the QFabric default partition IP address: ip address
(Optional) Enter the IPv6 addresses for both Director devices and the gateway IPv6
7.
address for the Director group.
Would you like to input IPv6 addresses for Director Group nodes? (y/n): y
Please enter the Director Group 0 IPv6 address or 'y' to use /0: IPv6 address
Please enter the Director Group 1 IPv6 address or 'y' to use /0: IPv6 address
Please enter the Director Group gateway IPv6 address or 'y' to use /0 : IPv6
address
Enter the MAC address information.
8.
Please enter the starting MAC address: mac address
Please enter the number of MAC addresses: number of mac addresses
NOTE: The minimum number of MAC addresses accepted is 4000.
Enter the QFabric system software serial number.
9.
Please enter the QFabric serial ID: serial id
Create the Director device root password.
10.
Please enter a Director device root password: director-device-password
Please re-enter password: director-device password
Create a password for the QFabric system components.
11.
NOTE: If you need to change the component password after the QFabric
system is operational, issue the
[edit system]
Please enter a password for QFabric components (Node devices, Interconnect
devices, and infrastructure): component-password
Please re-enter password: component-password
Chapter 38: Performing the Initial Configuration
device-authentication
hierarchy level in the QFabric default partition CLI.
statement at the
553