Connecting The Qfx10002; Figure 36: Attach Switch To Rack - Juniper QFX10002 Hardware Manual

QFX10002 Switch Hardware Guide
Related
Documentation

Connecting the QFX10002

96

Figure 36: Attach Switch to Rack

Continue to support the switch while sliding the rear mounting-blades into the channel
9.
of the side mounting-rails and securing the blades to the rack. Use the 8 mounting
screws (and cage nuts and washers if your rack requires them) to attach each blade
to the rack. Tighten the screws. See
Ensure that the switch chassis is level by verifying that all the screws on the front of
10.
the rack are aligned with the screws at the back of the rack.
Rack-Mounting and Cabinet-Mounting Warnings on page 151
Connecting the QFX10002 on page 96
Use the following topics to connect external devices and power to the QFX10002:
Connecting the QFX10002 to Ground on page 97
Connecting a QFX10002 to a Management Ethernet Device on page 98
Connecting a QFX Series Device to a Management Console on page 99
Connecting AC Power to a QFX10002 on page 100
Connecting DC Power to a QFX10002 on page 102
Figure 36 on page 96.
Copyright © 2019, Juniper Networks, Inc.