Figure 49: Attach 1 U Switch To Rack; Figure 50: Slide Mounting Rail Onto The Qfx5100-96S Rear Mounting Blade - Juniper QFX5100 Hardware Manual
Hide thumbs
Also See for QFX5100:
- Hardware manual (300 pages) ,
- Hardware documentation (966 pages) ,
- Quick start manual (2 pages)
Table of Contents
Advertisement
Copyright © 2017, Juniper Networks, Inc.
Figure 49: Attach 1 U Switch to Rack
Figure 50: Slide Mounting Rail onto the QFX5100-96S Rear Mounting
Blade
Continue to support the switch while sliding the rear mounting-blades into the channel
8.
of the side mounting-rails and securing the blades to the rack. Use the four mounting
screws (and cage nuts and washers if your rack requires them) to attach each blade
to the rack. (Use eight front-mounting screws for the QFX5100-96S.) Tighten the
screws. See
Figure 51 on page
Chapter 9: Unpacking and Mounting the Switch
104.
103
Advertisement
Table of Contents
