Show Ip Ospf Interface - Enterasys N Standalone (NSA) Series Configuration Manual

Routing Protocol Configuration Command Set
Configuring OSPF

13.2.3.26 show ip ospf interface

Use this command to display OSPF interface related information, including network type, priority,
cost, hello interval, and dead interval.
show ip ospf interface [vlan vlan-id]
Syntax Description
vlan vlan-id
Command Type
Router command.
Command Mode
Any router mode.
Command Defaults
If vlan-id is not specified, OSPF statistics will be displayed for all VLANs.
Example
This example shows how to display all OSPF related information for VLAN 1:
Matrix>Router1#show ip ospf interface vlan 1
Vlan 1 is UP
Internet Address
Router ID 182.127.64.1,Network Type BROADCAST,Cost: 10
Transmit Delay is 1 sec,State BACKUPDR,Priority 1
Designated Router id 182.127.62.1, Interface addr 182.127.63.1
Backup Designated Router id 182.127.63.2,
Timer intervals configured, Hello 10,Dead 40,Wait 40,Retransmit 5
Neighbor Count is 1, Adjacent neighbor count is 1
Adjacent with neighbor 182.127.63.1 (Designated Router)
Table 13-4
13-66 Matrix NSA Series Configuration Guide
(Optional) Displays OSPF information for a specific VLAN.
This VLAN must be configured for IP routing as described
in Section
182.127.63.2 Mask
provides an explanation of the command output.
2.3.1.
255.255.255.0,Area 0.0.0.0