show ip igmp snooping mrouter
Use this command to display information on statically configured and dynamically
learned multicast router ports.
Syntax
show ip igmp snooping mrouter [vlan vlan-id]
vlan-id - VLAN ID (Range: 1-4094)
Default Setting
Displays multicast router ports for all configured VLANs.
Command Mode
Privileged Exec
Command Usage
Multicast router port types displayed include Static or Dynamic.
Example
The following shows the ports in VLAN 1 which are attached to multicast routers:
Console#show ip igmp snooping mrouter vlan 1
VLAN M'cast Router Port
---- ------------------- -------
1
Eth 1/11
2
Eth 1/12
Console#
IP Interface Commands
DHCP is enabled by default on this switch, with an IP address of 0.0.0.0. To set an
IP address you need to use the ip dhcp restart command, or manually enter an
address using the ip address command. You may also need to a establish a default
gateway between this device and the management stations.
Command
ip address
ip default-gateway
ip dhcp restart
show ip interface
show ip redirects
ping
Type
Static
Dynamic
Table 4-73. IP Interface Command Syntax
Function
Sets the IP address for the current interface
Defines the default gateway through which an in-band
management station can reach this device
Submits a BOOTP or DCHP client request
Displays the IP settings for this device
Displays the default gateway configured for this device
Sends ICMP echo request packets to another node on the
network
IP Interface Commands
Mode
Page
IC
4-234
GC
4-235
PE
4-235
PE
4-236
PE
4-236
NE, PE 4-237
4-233
4