Startup And General Configuration; Startup And General Configuration Summary; Factory Default Settings - Enterasys Matrix 2G4072-52 Configuration Manual

This chapter describes factory default settings and the Startup and General Configuration set of
commands.
2.1

STARTUP AND GENERAL CONFIGURATION SUMMARY

At startup, the Matrix Series device is configured with many defaults and standard features. The
following sections provide information on how to review and change factory defaults, how to
customize basic system settings to adapt to your work environment, and how to prepare to run the
device in router mode.
2.1.1

Factory Default Settings

The following tables list factory default device settings available on the Matrix Series device.
Table 2-1 lists default settings for Matrix Series switch operation.
router mode operation.
Table 2-1 Default Device Settings for Basic Switch Operation
Device Feature
CDP discovery
protocol
CDP authentication
code
CDP hold time
CDP interval
Cisco Discovery
Protocol

Startup and General Configuration

Default Setting
Auto enabled on all ports.
Set to 00-00-00-00-00-00-00-00
Set to 180 seconds.
Transmit frequency of CDP messages set to 60 seconds.
Globally auto-enabled, enabled on ports.
Matrix DFE-Platinum and Diamond Series Configuration Guide
Table 2-2 lists default settings for
2
2-1