Stacking Configuration And Management Commands; Purpose; Commands; Show Switch - Enterasys SecureStack C2 Configuration Manual

Stacking Configuration and Management Commands

Stacking Configuration and Management Commands

Purpose

To review, individually configure and manage switches in a SecureStack C2 stack.

Commands

For information about...

show switch

show switch switchtype
show switch stack-ports
set switch
set switch copy-fw
set switch description
set switch movemanagement
set switch member
clear switch member
show switch
Use this command to display information about one or more units in the stack.
Syntax
show switch [status] [unit]
Parameters
status
unit
Defaults
If not specified, status and other configuration information about all units will be displayed.
Mode
Switch command, read‐only.
Usage
After a stack has been configured, you can use this command to physically confirm the identity of
each unit. When you enter the command with a unit number, the MGR LED of the specified
switch will blink for 10 seconds. The normal state of this LED is off for member units and steady
green for the manager unit.
2-6 Configuring Switches in a Stack
(Optional) Displays power and administrative status information for one
or more units in the stack.
(Optional) Specifies the unit(s) for which information will display.
Refer to page...
2-6
2-7
2-8
2-9
2-10
2-10
2-11
2-11
2-12