Packet Capture Commands; Purpose; Commands; Show Rmon Capture - Enterasys SecureStack C2 Configuration Manual

Parameters
index index |
channel channel
Defaults
None.
Mode
Switch command, read‐write.
Example
This example shows how to clear RMON filter entry 1:
C2(rw)->clear rmon filter index 1

Packet Capture Commands

Note that packet capture filter is sampling only and does not guarantee receipt of back‐to‐back
packets.

Purpose

To display RMON capture entries, configure, enable, or disable capture entries, and clear capture
entries.

Commands

For information about...

show rmon capture

set rmon capture
clear rmon capture
show rmon capture
Use this command to display RMON capture entries and associated buffer control entries.
Syntax
show rmon capture [index [nodata]]
Clears a specific filter entry, or all entries belonging to a specific channel.
Packet Capture Commands
Refer to page...
13-19
13-20
13-21
SecureStack C2 Configuration Guide 13-19