Interface Range Macro Name - Dell Z9500 Command Reference Manual

interface range macro name

interface range macro name
Run the interface-range macro to automatically configure the pre-defined range of interfaces.
Z9500
Syntax
interface range macro name
Parameters
name
Defaults none
Command CONFIGURATION
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
9.2(1.0)
8.3.19.0
8.3.11.1
8.3.7.0
8.1.1.0
7.6.1.0
7.5.1.0
6.2.1.0
Example (Single
This example displays the macro named test.
Range)
Dell(config)#interface range macro test
Dell(config-if-range-te-0/0-3,te-1/0-47,te-2/0-89)#
Dell
Related
interface range
Commands
interface range macro (define)
configuration).
Interfaces
– runs an interface range macro.
Enter the name of an existing macro.
Description
Introduced on the Z9500.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the E-Series ExaScale.
Introduced on the S-Series.
Introduced on the C-Series.
Introduced
— configures a range of command (bulk configuration).
— defines a macro for an interface range (bulk
851