Version
8.3.19.0
Version 8.3.11.1
Version 8.3.7.0
Version 8.5.1.0
Version 8.2.1.0
Version 8.1.1.0
Version 7.6.1.0
Version 7.5.1.0
pre-Version
6.1.1.0
Example (Single
This example shows how to define an interface range macro named test. Execute
Range)
the show running-config command to display the macro definition.
Dell(config)# define interface-range test
tengigabitethernet0/0-3,
gigabitethernet 5/0-47, gigabitethernet 13/0-89
Dell# show running-config | grep define
define interface-range test tengigabitethernet0/0-3,
gigabitethernet5/0-47,
gigabitethernet 13/0 - 89
Dell(config)#interface range macro test
Dell(config-if-range-te-0/0-3,gi-5/0-47,gi-13/0-89)#
Related
interface range
Commands
interface range macro name
interface range macro name
Run the interface-range macro to automatically configure the pre-defined range of interfaces.
S4810
Syntax
interface range macro name
Parameters
name
Defaults
none
Command
CONFIGURATION
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
758
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Added support for 4-port 40G line cards on ExaScale.
Added support for 4093 VLANs on E-Series ExaScale. Prior
releases supported 2094.
Introduced on the E-Series ExaScale.
Introduced on the S-Series.
Introduced on the C-Series.
Introduced on the E-Series.
– configures a range of command (bulk configuration)
– runs an interface range macro.
Enter the name of an existing macro.
Interfaces