Interface Range Macro Name - Dell S6000 Reference Manual

Related
interface range
Commands

interface range macro name

interface range macro name
Run the interface-range macro to automatically configure the pre-defined range of interfaces.
S6000
Syntax
interface range macro name
Parameters
name
Defaults none
Command CONFIGURATION
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0
Version
8.3.19.0
Version 8.3.11.1
Version 8.3.7.0
Version 8.1.1.0
Version 7.6.1.0
Version 7.5.1.0
Version 6.2.1.0
Example (Single
This example shows the macro named test that was defined earlier.
Range)
Dell(config)#interface range macro test
Dell(config-if-range-te-0/0-3,gi-5/0-47,gi-13/0-89)#
Dell
Related
interface range
Commands
interface range macro (define)
configuration).
Interfaces
– configures a range of command (bulk configuration)
– runs an interface range macro.
Enter the name of an existing macro.
Introduced on the S6000.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the E-Series ExaScale.
Introduced on the S-Series.
Introduced on the C-Series.
Introduced
— configures a range of command (bulk configuration).
— defines a macro for an interface range (bulk
649