Ip Igmp Snooping Last-Member-Query-Interval - Dell Z9500 Reference Manual

ip igmp snooping last-member-query-interval

The last member query interval is the maximum response time inserted into Group-Specific queries sent
in response to Group-Leave messages.
Z9500
Syntax
ip igmp snooping last-member-query-interval milliseconds
To return to the default value, use the no ip igmp snooping last-member-
query-interval command.
Parameters
milliseconds
Defaults 1000 milliseconds
Command INTERFACE VLAN
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
9.5(0.1)
9.2(0.0)
9.0.2.0
8.3.19.0
8.3.11.1
8.3.7.0
7.6.1.0
7.5.1.0
Usage This last-member-query-interval is also the interval between successive Group-
Information Specific Query messages. To change the last-member-query interval, use this
command.
Internet Group Management Protocol (IGMP)
Enter the interval in milliseconds. The range is from 100 to
65535. The default is 1000 milliseconds.
Description
Introduced on the Z9500.
Introduced on the M I/O Aggregator. This command is
supported in Programmable-Mux (PMUX) mode only.
Introduced on the S6000.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the S-Series.
Introduced on the C-Series.
797