Displaying A Sflow Sampler - Alcatel-Lucent OmniSwitch 9900 Series Network Configuration Manual

Diagnosing Switch Problems

Displaying a sFlow Sampler

The show sflow sampler
For example, to view the sFlow sampler table, enter the show sflow sampler command without specifying
any additional parameters. A screen similar to the following example is displayed, as shown below:
-> show sflow sampler
Instance Interface
-----------------------------------------------------------------
1 2/ 1
1 2/ 2
1 2/ 3
1 2/ 4
1 2/ 5
Note. For more information about the displays that result from these commands, see the OmniSwitch AOS
Release 8 CLI Reference Guide.
Displaying a sFlow Poller
The show sflow poller
For example, to view the sFlow poller table, enter the show sflow poller command without specifying any
additional parameters. A screen similar to the following example is displayed, as shown below:
-> show sflow poller
Instance Interface
-------------------------------------------
1 2/ 6
1 2/ 7
1 2/ 8
1 2/ 9
1 2/10
Note. For more information about the displays that result from these commands, see the OmniSwitch AOS
Release 8 CLI Reference Guide.
OmniSwitch AOS Release 8 Network Configuration Guide
command is used to display the sampler table.
Receiver Sample-rate
1 2048
1 2048
1 2048
1 2048
1 2048
command is used to display the poller table.
Receiver Interval
1 30
1 30
1 30
1 30
1 30
Sample-hdr-size
128
128
128
128
128
December 2017
sFlow
page 34-26