Displaying A Sflow Sampler; Displaying A Sflow Poller - Alcatel-Lucent OmniSwitch 6850-48 Network Configuration Manual

sFlow

Displaying a sFlow Sampler

The show sflow sampler
For example, to view the sFlow sampler table, enter the show sflow sampler command without specify-
ing any additional parameters. A screen similar to the following example will be displayed, as shown
below:
-> show sflow sampler
Instance Interface
-----------------------------------------------------------------
1 2/ 1
1 2/ 2
1 2/ 3
1 2/ 4
1 2/ 5
Note. For more information about the displays that result from these commands, see the OmniSwitch CLI
Reference Guide.

Displaying a sFlow Poller

The show sflow poller
For example, to view the sFlow poller table, enter the show sflow poller command without specifying any
additional parameters. A screen similar to the following example will be displayed, as shown below:
-> show sflow poller
Instance Interface
-------------------------------------------
1 2/ 6
1 2/ 7
1 2/ 8
1 2/ 9
1 2/10
Note. For more information about the displays that result from these commands, see the OmniSwitch CLI
Reference Guide.
page 45-32
command is used to display the sampler table.
Receiver Sample-rate
1 2048
1 2048
1 2048
1 2048
1 2048
command is used to display the poller table.
Receiver Interval
1 30
1 30
1 30
1 30
1 30
OmniSwitch AOS Release 6 Network Configuration Guide
Diagnosing Switch Problems
Sample-hdr-size
128
128
128
128
128
September 2009