Agilent Technologies InfiniiVision 4000 X-Series Programmer's Manual page 5

•
•
•
•
•
•
•
•
•
•
•
•
•
•
The command descriptions in this reference show upper and lowercase
characters. For example, :AUToscale indicates that the entire command
name is :AUTOSCALE. The short form, :AUT, is also accepted by the
oscilloscope.
Then, there are chapters that describe programming topics and conceptual
information in more detail:
Agilent InfiniiVision 4000 X-Series Oscilloscopes Programmer's Guide
Chapter 24, ":POD Commands," starting on page 541, describes
commands that control all oscilloscope functions associated with groups
of digital channels.
Chapter 25, ":POWer Commands," starting on page 547, describes
commands that control the DSOX4PWR power measurement application.
Chapter 26, ":RECall Commands," starting on page 613, describes
commands that recall previously saved oscilloscope setups, reference
waveforms, or masks.
Chapter 27, ":SAVE Commands," starting on page 621, describes
commands that save oscilloscope setups, screen images, and data.
Chapter 28, ":SBUS<n> Commands," starting on page 645, describes
commands that control oscilloscope functions associated with the serial
decode bus and serial triggering.
Chapter 29, ":SEARch Commands," starting on page 817, describes
commands that control oscilloscope functions associated with searching
for waveform events.
Chapter 30, ":SYSTem Commands," starting on page 909, describes
commands that control basic system functions of the oscilloscope.
Chapter 31, ":TIMebase Commands," starting on page 923, describes
commands that control all horizontal sweep functions.
Chapter 32, ":TRIGger Commands," starting on page 935, describes
commands that control the trigger modes and parameters for each
trigger type.
Chapter 33, ":WAVeform Commands," starting on page 1019, describes
commands that provide access to waveform data.
Chapter 34, ":WGEN<w> Commands," starting on page 1055, describes
commands that control waveform generator (Option WGN) functions and
parameters.
Chapter 35, ":WMEMory<r> Commands," starting on page 1099,
describes commands that control reference waveforms.
Chapter 36, "Obsolete and Discontinued Commands," starting on page
1109, describes obsolete commands which still work but have been
replaced by newer commands and discontinued commands which are no
longer supported.
Chapter 37, "Error Messages," starting on page 1167, lists the
instrument error messages that can occur while programming the
oscilloscope.
5