Agilent Technologies InfiniiVision 4000 X-Series Programmer's Manual page 38

1
What's New
Command
:MEASure:CPLoss (see
page
:POWer:SIGNals:CYCLes:HAR
Monics (see
:POWer:SIGNals:CYCLes:QUA
Lity (see
:POWer:SIGNals:DURation:EF
Ficiency (see
:POWer:SIGNals:DURation:M
ODulation (see
:POWer:SIGNals:DURation:ON
OFf:OFF (see
:POWer:SIGNals:DURation:ON
OFf:ON (see
:POWer:SIGNals:DURation:RIP
Ple (see
:POWer:SIGNals:DURation:TR
ANsient (see
:POWer:SIGNals:VMAXimum:I
NRush (see
:POWer:SIGNals:VMAXimum:
ONOFf:OFF (see
:POWer:SIGNals:VMAXimum:
ONOFf:ON (see
:POWer:SIGNals:VSTeady:ON
OFf:OFF (see
:POWer:SIGNals:VSTeady:ON
OFf:ON (see
:POWer:SIGNals:VSTeady:TRA
Nsient (see
:SBUS<n>:USB Commands
(see
:SEARch:SERial:USB
Commands (see
:SYSTem:TOUCh (see
page
:TIMebase:REFClock (see
page
38
491)
page 582)
page 583)
page 584)
page 585)
page 586)
page 587)
page 588)
page 589)
page 592)
page 593)
page 594)
page 595)
page 596)
page 597)
page 792)
page 891)
922)
928)
Agilent InfiniiVision 4000 X-Series Oscilloscopes Programmer's Guide
Description
Installs a power loss per cycle measurement on screen or
returns the measured value.
Specifies the number of cycles to include in the current
harmonics analysis.
Specifies the number of cycles to include in the power quality
analysis.
Specifies the duration of the efficiency analysis.
Specifies the duration of the modulation analysis.
Specifies the duration of the turn off analysis.
Specifies the duration of the turn on analysis.
Specifies the duration of the output ripple analysis.
Specifies the duration of the transient response analysis.
Specifies the maximum expected input voltage for inrush
current analysis.
Specifies the maximum expected input voltage for turn off
analysis.
Specifies the maximum expected input voltage for turn on
analysis.
Specifies the expected steady state output DC voltage of the
power supply for turn off analysis.
Specifies the expected steady state output DC voltage of the
power supply for turn on analysis.
Specifies the expected steady state output DC voltage of the
power supply for transient response analysis.
Commands for using the USB 2.0 triggering and serial decode
feature.
Commands for searching USB 2.0 serial decode events.
Disables or enables the touchscreen.
Lets you enable or disable the use of a 10 MHz reference input
signal.