Agilent Technologies InfiniiVision 4000 X-Series Programmer's Manual page 42

1
What's New
Discontinued Command
:POWer:SIGNals:VSTeady
:POWer:SLEW:VALue
:PWRenable
:PWRRegister[:EVENt]
:TRIGger:USB:SOURce:DMINu
s
:TRIGger:USB:SOURce:DPLus
:TRIGger:USB:SPEed
:TRIGger:USB:TRIGger
42
Current Command Equivalent
:POWer:SIGNals:VSTeady:ON
OFf:OFF (see page 595)
:POWer:SIGNals:VSTeady:ON
OFf:ON (see page 596)
:POWer:SIGNals:VSTeady:TRA
Nsient (see page 597)
none
none
none
none
none
none
none
Agilent InfiniiVision 4000 X-Series Oscilloscopes Programmer's Guide
Comments
This command was separated
into several other commands
for specific types of power
analysis.
Slew rate values are now
displayed using max and min
measurements of a
differentiate math function
signal.
The Power Event Enable
Register does not exist in the
4000 X-Series oscilloscopes.
The Power Event Event
Register does not exist in the
4000 X-Series oscilloscopes.
These USB trigger commands
are superseded by commands
that are available with the
DSOX4USBFL (USB 2.0
Full/Low Speed) or
DSOX4USBH (USB 2.0 High
Speed) serial decode and
triggering licenses. See
":SBUS<n>:USB
Commands" on page 792.