Version 8.3.7.0
Version 7.6.1.0
Version 7.5.1.0
pre-Version
6.2.1.1
Usage
When you use the no tagged command, the interface is automatically placed in
Information
the Default VLAN as an untagged interface unless the interface is a member of
another VLAN. If the interface belongs to several VLANs, remove it from all VLANs
to change it to an untagged interface.
Tagged interfaces can belong to multiple VLANs, while untagged interfaces can
only belong to one VLAN at a time.
Related
interface vlan
Commands
untagged
track ip
Track the Layer 3 operational state of a Layer 3 VLAN, using a subset of the VLAN member interfaces.
S6000
Syntax
track ip interface
To remove the tracking feature from the VLAN, use the no track ip interface
command.
Parameters
interface
Defaults
Not configured.
Command
INTERFACE VLAN
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Layer 2
Introduced on the S4810.
Introduced on the S-Series.
Introduced on the C-Series.
Introduced on the E-Series.
— configures a VLAN.
— specifies which interfaces in a VLAN are untagged.
Enter the following keywords and slot/port or number
information:
•
For a Port Channel interface, enter the keywords port-
channel then a number. The range is from 1 to 128.
•
For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port information.
•
For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE then the slot/port information.
885