Table of Contents
Advertisement
Adjustment
Ensure that the electricity to the machine is switched off while performing tasks that do
not need electricity. Refer to
GP
14. Disconnect the power cord. Electricity can cause
death or injury. Moving parts can cause injury.
1.
Perform the following:
a.
Enter Service Mode
GP 1
b.
Select Adjustment Routines.
c.
Select 131 NVM Read / Write...
d.
Enter NVMID 12-005 BookMrkFoldOffset.
e.
Select Read/Write.
f.
Enter the new value to correct the error found during the check.
NOTE: Increasing the value increases the width of the top sheet of the booklet
(moves the fold away from the left edge). Decreasing the value decreases the width
of the top sheet of the booklet (moves the fold towards the left edge). One step =
0.1137 mm.
g.
Select Save, then OK.
2.
Select Save, then select OK.
3.
When the crease position is correct, switch the machine off then on,
Repairs/Adjustments
ADJ 12.7-171, ADJ 12.8-171
WARNING
GP
14.
ADJ 12.8-171 Booklet Staple Position
Purpose
To set the position of the staples so that they are positioned on the fold of the booklet.
Check
1.
Run a copy job of 3 stapled 4 sheet booklets.
2.
Observe the position of the staple in relation to the fold of the booklet. The staple should
be positioned in the middle of the fold. If necessary perform the adjustment.
Adjustment
Ensure that the electricity to the machine is switched off while performing tasks that do
not need electricity. Refer to
death or injury. Moving parts can cause injury.
1.
Perform the following:
a.
Enter Service Mode
b.
Select Adjustment Routines.
c.
Select
dC131
NVM Read / Write.
d.
Enter the NVMID as required:
•
12-004 BookMrkStapleOffset for 8.5 x 11 inch and A4.
•
12-012 BookMrkStapleOffsetM for 8.5 x 13 inch and 8.5 x 14 inch.
•
12-013 BookMrkStapleOffsetL for 11 x 17 inch and A3.
e.
Select Read / Write.
f.
Enter the new value to correct the error found during the check.
NOTE: One step = 0.1137 mm. If it is necessary to change the value for one size,
the values of other sizes may also be incorrect. If paper is available, perform the
Check for all size settings.
g.
Select Save, then OK.
h.
Enter NVMID 12-005 BookMrkFoldOffset.
i.
Select Read / Write.
j.
Change the value by the same amount as the BookMrkStapleOffset value.
NOTE: Increasing both values moves the staple position toward the left edge of the
top sheet. Decreasing both values moves the staple position away. Changing only
the BookMrkStapleOffset value will move the staple position and fold position the
same amount.
k.
Select Save, then OK.
2.
Repeat the Check to ensure the staple position is correct.
3.
When the staple position is correct, switch the machine off then on,
February 2013
4-410
WARNING
GP
14. Disconnect the power cord. Electricity can cause
GP
1.
ColorQube® 9303 Family
GP
14.
Advertisement
Chapters
Table of Contents
