Immobilizer Control System; Precautions In Diagnosing Troubles; Precaution In Replacing Ecm; Precaution In Replacing Ignition Key - Suzuki SX4 Service Manual

Hide thumbs Also See for SX4:
Table of Contents

Advertisement

10C-1 Immobilizer Control System:

Immobilizer Control System

Control Systems

Precautions in Diagnosing Troubles

• Before confirming the diagnostic trouble code (DTC),
do not disconnect connector from ECM, battery cable
from battery, ground wire harness, or main fuse. Such
disconnection will erase DTC stored in ECM.
• DTC stored in ECM memory can be checked as well
as cleared by using SUZUKI scan tool. Before using
SUZUKI scan tool, read its operator's manual
carefully to know how to use it and what functions are
available.
• Be sure to read "Precautions for Electrical Circuit
Service in Section 00" before inspection.
• Communication of ECM, BCM, ABS control module,
TCM (if equipped), 4WD control module (if equipped),
keyless start control module (if equipped),
combination meter and DLC is established by CAN
(Controller Area Network). Therefore, handle CAN
communication lines with care referring to "Precaution
for CAN Communication System in Section 00".
For CAN communication system, refer to description
on "CAN Communication System Description in
Section 1A".

Precaution in Replacing ECM

• If ECM is replaced with new or used one without
Immobilizer control function, the engine will not be
started. In case of the above, check if the newly
installed ECM has Immobilizer control function.
• After ECM is replaced with new one or used one, the
transponder code in the transponder built in the
ignition key has to be registered with ECM. Or, the
engine cannot be started up. For the registration
procedure, refer to "Procedure after ECM
Replacement".

Precaution in Replacing Ignition Key

To register ignition key in case of replacing key(s) and/or
making spare key(s), the transponder code in the ignition
key is registered with ECM. Or the engine can not be
started up. For the registration procedure, refer to
"Registration of the Ignition Key".
Precautions

Precautions in Handling Immobilizer Control

S7RW0AA300001
System
• Do not turn ON ignition switch with ignition key in
contact with another one or quite close to another
one. Or, the immobilizer control system may detect
some abnormal condition and prevent the engine from
starting.
• Do not turn ON ignition switch by using ignition key
with any type of metal (1) wrapped its grip or in
contact with it. Or, the immobilizer control system may
detect some abnormal condition and prevent the
engine from starting.
S7RW0AA300002
S7RW0AA300003
S7RW0AA300004
I3RH0AA30001-01
1
I3RH0AA30002-01

Advertisement

Table of Contents
loading

Table of Contents