Dtc Clearance - Suzuki SX4 Service Manual

3) Check DTC displayed on odometer of combination meter or read flashing pattern of theft deterrent light which
represents DTC as shown in the following example and write it down.
When more than 2 DTCs are stored in memory, flashing for each DTC starts with the smallest DTC number in
increasing order. Also, DTC is indicated repeatedly until the ignition switch is turned OFF.
[A]
0
A
B
T2
[B]
1
A
B
T2
T1
[C]
1
A
B
T2
T1
[A]: No DTC (No. 0000)
[B]: DTC B1133 (No. 1133)
[C]: When 2 DTCs are detected
4) After completing the check, turn ignition switch to OFF position.

DTC Clearance

After repair or replace of malfunction part(s), clear all DTCs by performing the following procedure.
Using SUZUKI Scan Tool
1) Connect SUZUKI scan tool to data link connector in the same manner as when making this connection for DTC
check.
2) Turn ignition switch ON and engine stops.
3) Erase DTC according to instructions displayed on scan tool. Refer to scan tool operator's manual for further
details.
4) After completing the clearance, turn ignition switch off and disconnect scan tool from data link connector.
Without Using SUZUKI Scan Tool
1) Turn ignition switch to OFF position.
2) Perform following Steps a) to d) within 10 seconds after ignition switch is turned ON and engine stops.
a) Turn headlight switch to "SMALL" position.
b) Turn headlight switch to "OFF" position.
c) Repeat Steps a) and b) 3 times.
d) Press and release driver side door switch 4 times.
3) After completing above Steps, confirm that no malfunction DTC is detected.
0 0 0
T2 T2 T2
1 3 3
T2 T2
T1 T1 T1
1 3 3
T2 T2
T1 T1 T1
A: Indicator lamp turned ON
B: Indicator lamp turned OFF
T1: 0.3 seconds
Body Electrical Control System:
2
1 1 6
T3 T2 T2
T1 T1 T1
T2: 1.0 seconds
T3: 3.0 seconds
1. Theft deterrent light
1
0
T2 T2
I5RW0AA20009-01
2. Odometer
S7RW0AA204006
10B-16