Neighbor Route-Reflector-Client - Dell Z9500 Command Reference Manual

Hide thumbs Also See for Z9500:

Table of Contents

When you apply a route map to outbound routes, only routes that match at least

one section of the route map are permitted.

If you identify a peer group by name, the peers in that peer group inherit the

characteristics in the Route map used in this command. If you identify a peer by IP

address, the Route map overwrites either the inbound or outbound policies on that

neighbor route-reflector-client

Configure the router as a route reflector and the specified neighbors as members of the cluster.

neighbor {ip-address | peer-group-name} route-reflector-client

To remove one or more neighbors from a cluster, use the no neighbor {ip-

address | peer-group-name} route-reflector-client command. If you

delete all members of a cluster, you also delete the route-reflector configuration

on the router.

Not configured.

This guide is platform-specific. For command information about other platforms,

refer to the relevant Dell Networking OS Command Line Reference Guide.

The following is a list of the Dell Networking OS version history for this command.

Introduced on the S-Series.

Introduced on the C-Series.

Enter the IP address of the neighbor in dotted decimal

Enter the name of the peer group.

All routers in the peer group receive routes from a route

Introduced on the Z9500.

Introduced on the S4820T.

Introduced on the Z9000.

Border Gateway Protocol