Neighbor Remove-Private-As - Dell Z9500 Command Reference Manual

Related
router bgp
Commands
bgp four-octet-as-support

neighbor remove-private-as

Remove private AS numbers from the AS-PATH of outgoing updates.
Z9500
Syntax
neighbor {ip-address | peer-group-name} remove-private-as
To return to the default, use the no neighbor {ip-address | peer-group-
name} remove-private-as command.
Parameters
ip-address
peer-group-
name
Defaults Disabled (that is, private AS number are not removed).
Command ROUTER BGP
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
9.2(1.0)
8.3.19.0
8.3.11.1
8.3.7.0
7.8.1.0
7.7.1.0
Usage
Applies to EBGP neighbors only.
Information
Configure your system to accept 4-byte formats before entering a 4 byte AS
Number.
If the AS-PATH contains both public and private AS number or contains AS
numbers of an EBGP neighbor, the private AS numbers are not removed.
428
— enters ROUTER BGP mode and configures routes in an AS.
— enables 4-byte support for the BGP process.
Enter the IP address of the neighbor to remove the private AS
numbers.
Enter the name of the peer group to remove the private AS
numbers.
Description
Introduced on the Z9500.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the S-Series.
Introduced on the C-Series. Added 4-byte support.
Border Gateway Protocol