Installing A Power Supply In A Qfx3600 Or Qfx3600-I Device - Juniper QFX5110 Series Hardware Documentation

Figure 156: Removing a Power Supply from a QFX3600 or QFX3600-I Device
AC
DC
!
NOTE: If you have a Juniper Care service contract, register any addition, change, or upgrade of
hardware components at
. Failure to do so can result in significant delays if you need replacement parts. This note does
not apply if you replace existing components with the same type of component.
RELATED DOCUMENTATION
AC Power Supply for a QFX3500, QFX3600, or QFX3600-I Device
DC Power Supply for a QFX3500, QFX3600, or QFX3600-I Device
Field-Replaceable Units for QFX3600 and QFX3600-I Devices
Rear Panel of QFX3600 and QFX3600-I Devices
Connecting AC Power to a QFX3500, QFX3600, or QFX3600-I Device | 309
Connecting DC Power to a QFX3500, QFX3600, or QFX3600-I Device | 312

Installing a Power Supply in a QFX3600 or QFX3600-I Device | 447

Installing a Power Supply in a QFX3600 or QFX3600-I Device
The QFX3600 and QFX3600-I devices are shipped from the factory with two 650 W power supplies
pre-installed. Each power supply is a hot-removable and hot-insertable field-replaceable unit (FRU) when
the second power supply is installed and running. You can install replacement power supplies on the rear
panel without powering off the device or disrupting the switching function.
Before you install a power supply in a QFX3600 device, ensure that you have taken the necessary
precautions to prevent electrostatic discharge (ESD) damage (see
Damage" on page 242).
https://www.juniper.net/customers/support/tools/updateinstallbase/
"Prevention of Electrostatic Discharge
447