Connecting An Ex4600 Switch To A Network For Out-Of-Band Management; Figure 26: Connecting An Ex Series Switch To A Management Console Through; Figure 27: Connecting An Ex Series Switch Directly To A Management - Juniper EX4600 Series Hardware Manual

Related
Documentation

Connecting an EX4600 Switch to a Network for Out-of-Band Management

Copyright © 2014, Juniper Networks, Inc.
Figure 26: Connecting an EX Series Switch to a Management Console
Through a Console Server

Figure 27: Connecting an EX Series Switch Directly to a Management

Console
Configuring the Console Port Type (CLI Procedure)
Connecting an EX Series Switch to a Network for Out-of-Band Management
Console Port Connector Pinout Information for an EX Series Switch on page 45
Cables Connecting the EX6200 Switch to Management Devices
Cables Connecting the EX8200 Switch to Management Devices
You can monitor and manage the EX4600 device using a dedicated management channel.
EX4600 devices have two management ports: a 10/100/1000BASE-T RJ-45 port and a
1-Gbps SFP ports. Use the management ports to connect the EX4600 switch to a network
for out-of-band management.
CAUTION: Configuring the two management interfaces within the same
subnet is not supported.
NOTE: You cannot use the management ports to perform the initial
configuration of the EX4600 switch. You must configure the management
ports before you can successfully connect to the EX4600 switch using these
ports. See "Configuring an EX4600 Switch" on page
Ensure that you have an appropriate cable available. See
and Management Connections for the EX4600" on page 44
for SFP, SFP+, and QSFP+ Transceivers for the EX4600 Switch" on page 49
Chapter 17: Connecting the EX4600 Device
159.
"Cable Specifications for Console
and "Interface Specifications
155