Qfx10002 Management Port Leds; Figure 21: Qfx10002 Management Panel Components - Juniper QFX10002 Hardware Manual

QFX10002 Switch Hardware Guide
See Also

QFX10002 Management Port LEDs

46

Figure 21: QFX10002 Management Panel Components

1— em0–RJ-45 (1000BASE-T) management
Ethernet port ( MGMT ).
2— RJ-45 console port ( CON
RS-232 serial ports. The LED below the port
indicates status and link.
3— Reset button. Press and hold 5 seconds to
reset the hardware. Clock functions and
FPGA status registers are not reset.
4— PWR
Status LEDs–Power (
MJR
major alarm ( ), and minor alarm (
5—em1–SFP management Ethernet port
MGMT
( ).
USB Port Specifications for the QFX Series on page 87
Connecting a QFX10002 to a Management Ethernet Device on page 98
There are two managements ports on a QFX10002 that have LEDs that indicate link
status and link activity. These two ports, located on the management panel next to the
access ports, are both labeled
BASE-T connections and the lower port is for 10/100/1000 BASE-T and small-form
pluggable (SFP) 1000 BASE-X connections (see
port has separate LEDs for status and activity. The fiber, SFP, port has a combination
link and activity LED.
6— PTP Ethernet–SFP (1000BASE-T) port
( ETH
) to support 7— 10 Hz pulses-per-second (
SubMiniature B (SMB) connector for input
and output measuring of the timing drift to
and from a grandmaster clock
8—
10 MHz SMB timing connector (
STA 9— USB port
), status ( ),
MIN
).
. The top management port is for 10/100/1000
MGMT
Figure 22 on page
)
PPS )
10MHz
47). The copper, RJ45,
Copyright © 2019, Juniper Networks, Inc.
)