Ethernet Interface Configuration Commands; General Ethernet Interface And Subinterface Configuration Commands; Bandwidth; Combo Enable - HP 6600 Command Reference Manual

Ethernet interface configuration commands

General Ethernet interface and subinterface
configuration commands

bandwidth

Use bandwidth to set the intended bandwidth for an Ethernet interface.
Use undo bandwidth to cancel the configuration.
Syntax
bandwidth bandwidth-value
undo bandwidth
Views
Ethernet interface view
Default command level
2: System level
Parameters
bandwidth-value: Sets the intended bandwidth, in the range of 1 to 4,294,967,295 kbps.
Usage guidelines
You can obtain the intended bandwidth of an interface by querying the ifspeed value of the MIB node
with third-party software.
The intended bandwidth is used by network management systems for monitoring bandwidth, but does
not affect the actual bandwidth of the interface.
Examples
# Set the intended bandwidth to 10,000 kbps for interface GigabitEthernet 1/0/1.
<Sysname> system-view
[Sysname] interface gigabitethernet 1/0/1
[Sysname-GigabitEthernet1/0/1] bandwidth 10000

combo enable

Use combo enable to activate the copper or fiber combo port.
Syntax
combo enable { copper | fiber }
Default
The copper combo port is activated.
1