Table of Contents
Advertisement
To enter ROUTER OSPF mode:
1.
Verify that you are logged in to CONFIGURATION mode.
2.
Enter the router ospf {process-id} command. The prompt changes to include (conf-
router_ospf-id).
You can switch to INTERFACE mode by using the interface command or you can switch to ROUTER
RIP mode by using the router rip command.
ROUTER RIP Mode
To enable and configure Router Information Protocol (RIP), use ROUTER RIP mode. For more
information, refer to
Routing Information Protocol
To enter ROUTER RIP mode:
1.
Verify that you are logged in to CONFIGURATION mode.
2.
Enter the router rip command. The prompt changes to include (conf-router_rip).
You can return to CONFIGURATION mode by using the exit command.
SPANNING TREE Mode
To enable and configure the Spanning Tree protocol, use SPANNING TREE mode. For more information,
refer to
Spanning Tree Protocol
To enter SPANNING TREE mode:
1.
Verify that you are logged in to CONFIGURATION mode.
2.
Enter the protocol spanning-tree stp-id command. The prompt changes to include (conf-
stp).
You can return to CONFIGURATION mode by using the exit command.
58
(RIP).
(STP).
CLI Basics
Advertisement
Table of Contents
