Show Boot System; Set Boot System - Enterasys SecureStack C2 C2G170-24 Configuration Manual

show boot system

show boot system
Use this command to display the firmware image the switch loads at startup.
Syntax
show boot system
Parameters
None.
Defaults
None.
Mode
Switch command, read‐only.
Example
This example shows how to display the switch's boot firmware image:
C2(su)->show boot system
Current system image to boot: bootfile

set boot system

Use this command to set the firmware image the switch loads at startup.
Syntax
set boot system filename
Parameters
filename
Defaults
None.
Mode
Switch command, read‐write.
Usage
This command allows you to set the firmware image to be loaded at startup. You can choose to
reset the system to use the new firmware image immediately, or you can choose to only specify the
new image to be loaded the next time the switch is rebooted.
You can use the dir command to display the "Active" image and the "Boot" image, which will be
the image loaded at the next system reboot.
3-34 Basic Configuration
Specifies the name of the firmware image file.
Note: If you are changing the firmware image to a version earlier than the current version, refer to
"Reverting to a Previous Image" on page 3-33 for the correct steps to follow.