Set Multiauth Port; Clear Multiauth Port - Enterasys SecureStack C2 Configuration Manual

set multiauth port

Use this command to set multiple authentication properties for one or more ports.
Syntax
set multiauth port mode {auth-opt | auth-reqd | force-auth | force-unauth} |
numusers numusers port-string
Parameters
mode
auth‐opt |
auth‐reqd |
force‐auth |
force‐unauth
numusers
numusers
port‐string
Defaults
None.
Mode
Switch command, read‐write.
Example
This example shows how to set the port multiple authentication mode to required on
C2(rw)->set multiauth port mode auth-reqd ge.3.14

clear multiauth port

Use this command to clear multiple authentication properties for one or more ports.
Syntax
clear multiauth port {mode | numusers} port-string
Parameters
mode
numusers
port‐string
Specifies the port(s)' multiple authentication mode as:
• auth‐opt — Authentication optional ("non‐strict" behavior). If a user
does not attempt to authenticate using 802.1x, or if 802.1x
authentication fails, the port will allow traffic to be forwarded
according to the defined default VLAN.
• auth‐reqd — Authentication is required.
• force‐auth — Authentication considered.
• force‐unauth — Authentication disabled.
Specifies the number of users allowed authentication on port(s). Valid
values are 0 to 8.
Specifies the port(s) on which to set multiple authentication properties.
Clears the specified port's multiple authentication mode.
Clears the value set for the number of users allowed authentication on the
specified port.
Specifies the port or ports on which to clear multiple authentication
properties.
set multiauth port
SecureStack C2 Configuration Guide 18-35
.3.14:
ge