Show Radius - Enterasys N Standalone (NSA) Series Configuration Manual

Security Configuration Command Set
Configuring RADIUS
14.3.2.1

show radius

Use this command to display the current RADIUS client/server configuration.
show radius [state | retries authtype || timeout | server [index | all]]
Syntax Description
state
retries
authtype
server
timeout
index | all
Command Type
Switch command.
Command Mode
Read-Only.
Command Defaults
If no parameters are specified, all RADIUS configuration information will be
displayed.
Example
This example shows how to display RADIUS configuration information:
Matrix(rw)->show radius
RADIUS state:
RADIUS retries:
RADIUS timeout:
RADIUS Server
---------- --------------- ---------
1
14-10 Matrix NSA Series Configuration Guide
(Optional) Displays the RADIUS client's enable status.
(Optional) Displays the number of retry attempts before the
RADIUS server times out.
(Optional) Displays the RADIUS server's authentication
type.
(Optional) Displays RADIUS server configuration
information.
(Optional) Displays the maximum amount of time (in
seconds) to establish contact with the RADIUS server
before retry attempts begin.
(Optional) Displays configuration information for a
specified server or all RADIUS servers.
Enabled
2
3 seconds
IP Address
100.10.0.100
Auth-Port Realm-Type
------------------
1812 any
Status
-------
Active