Commands; Show Radius - Enterasys SecureStack C2 C2G170-24 Configuration Manual

show radius

Commands

For information about...
show radius
set radius
clear radius
show radius accounting
set radius accounting
clear radius accounting
show radius
Use this command to display the current RADIUS client/server configuration.
Syntax
show radius [status | retries | timeout | server [index | all]]
Parameters
status
retries
timeout
server
index | all
Defaults
If no parameters are specified, all RADIUS configuration information will be displayed.
Mode
Switch command, read‐only.
Example
This example shows how to display RADIUS configuration information:
C2(rw)->show radius
RADIUS status:
RADIUS retries:
RADIUS timeout:
RADIUS Server
--------------
10
Table 23‐1 provides an explanation of the command output.
23-4 Authentication and Authorization Configuration
(Optional) Displays the RADIUS server's enable status.
(Optional) Displays the number of retry attempts before the RADIUS server
times out.
(Optional) Displays the maximum amount of time (in seconds) to establish
contact with the RADIUS server before retry attempts begin.
(Optional) Displays RADIUS server configuration information.
For use with the server parameter to show server configuration for all
servers or a specific RADIUS server as defined by an index.
Enabled
3
20 seconds
IP Address Auth-Port
---------- ---------
172.16.20.10
Realm-Type
-----------------
1812 management-access
Refer to page...
23-4
23-5
23-7
23-7
23-8
23-9