Ip Ospf Retransmit-Interval; Ip Ospf Transmit-Delay - Enterasys SecureStack C2 Configuration Manual

ip ospf retransmit-interval

ip ospf retransmit-interval
Use this command to set the amount of time between retransmissions of link state advertisements
(LSAs) for adjacencies that belong to an interface. The no form of this command resets the
retransmit interval value to the default, 5 seconds.
Syntax
ip ospf retransmit-interval seconds
no ip ospf retransmit-interval
Parameters
seconds
Defaults
None.
Mode
Interface configuration: C2
Example
This example shows how to set the OSPF retransmit interval for the VLAN 1 interface to 20:
C2(su)->router(Config)#interface vlan 1
C2(su)->router(Config-if(Vlan 1))#ip ospf retransmit-interval 20

ip ospf transmit-delay

Use this command to set the amount of time required to transmit a link state update packet on an
interface. The no form of this command resets the retransmit interval value to the default, 1
second.
Syntax
ip ospf transmit-delay seconds
no ip ospf transmit-delay
Parameters
seconds
Defaults
None.
Mode
Interface configuration: C2
17-16 IPv4 Routing Protocol Configuration
Specifies the retransmit time in seconds. Valid values are 1 to 65535.
(su)‐>router(Config‐if(Vlan 1))#
Specifies the transmit delay in seconds. Valid values are from 1 to 65535.
(su)‐>router(Config‐if(Vlan 1))#