Configuring Igmp On Routing Interfaces - Enterasys SecureStack C2 Configuration Manual

Parameters
None.
Defaults
None.
Mode
Switch command, read‐write.
Example
This example shows how to clear all IGMP snooping entries:
C2(su)->clear igmpsnooping
Are you sure you want to clear all IGMP snooping entries? (y/n) y
IGMP Snooping Entries Cleared.

Configuring IGMP on Routing Interfaces

Purpose
To configure IGMP on routing interfaces.
Commands
For information about...
ip igmp
ip igmp enable
ip igmp version
show ip igmp interface
show ip igmp groups
ip igmp query-interval
ip igmp query-max-response-time
ip igmp startup-query-interval
ip igmp startup-query-count
ip igmp last-member-query-interval
ip igmp last-member-query-count
ip igmp robustness
Router: The commands covered in this section can be executed only when the device is in router
mode. For details on how to enable router configuration modes, refer to
Configuration Modes" on page 15-2.
Configuring IGMP on Routing Interfaces
"Enabling Router
Refer to page...
11-10
11-10
11-11
11-11
11-12
11-12
11-13
11-14
11-14
11-15
11-15
11-16
SecureStack C2 Configuration Guide 11-9