Displaying The Unicast Address Table - Enterasys Vertical Horizon VH-2402S2 Configuration Manual

Displaying the Unicast Address Table

The Address Table contains the MAC addresses and VLAN identifier
associated with each port (that is, the source port associated with the
address and VLAN), sorted by MAC address or VLAN ID. You can search
for a specific address, clear the entire address table, or information
associated with a specific address, or set the aging time for deleting
inactive entries.
Aging Time : 300
MAC
------------------------------------------------------------------------------
Sorted by : MAC + VID
VLAN ID : 1
MAC : 00-00-00-00-00-00
[Show]
<APPLY>
Use <TAB> or arrow keys to move, other keys to make changes.
Parameter
Aging Time
Dynamic Counts
Static Counts
MAC
VID
Unit
Port
Status
[Show]
[More]
[Clear]
[Clear Dynamic]
66 VH-2402S2 User Interface
Vertical Horizon Stack Local Management
Unicast Address Table
Dynamic Counts : 0
VID Unit Port Status
[More]
Figure 2-51. Unicast Address Table
Description
Time-out period in seconds for aging out dynamically learned
forwarding information.
Range: 10 - 415 seconds; Default: 300 seconds
The number of dynamically learned addresses in the table.
The number of static addresses in the table.
The MAC address of a node.
The VLAN(s) associated with this address or port.
Switch unit in the stack (1~7).
The port whose address table includes this MAC address.
Indicates address status as:
D: Dynamically learned, or
P: Fixed permanently by SNMP network management software.
Displays the address table based on specified VLAN ID, and
sorted by primary key MAC or VID.
Scrolls through the entries in the address table.
Clears the specified MAC address.
Clears all dynamically learned MAC addresses in the table.
Static Counts : 0
MAC
Cleared by : MAC + VID
VLAN ID
MAC
[Clear]
<OK>
VID Unit Port Status
: 1
: 2D-2D-2D-2D-2D-2D
[Clear Dynamic]
<CANCEL>
VH-2402S2