Ip Rip Enable; Distance - Enterasys SecureStack C2 Configuration Manual

Example
This example shows how to enable RIP:
C2(su)->router#configure
C2(su)->router(Config)#router rip
C2(su)->router(Config-router)#

ip rip enable

Use this command to enable RIP on an interface. The no form of this command disables RIP on an
interface: By default, RIP is disabled on all interfaces.
Syntax
ip rip enable
no ip rip enable
Parameters
None.
Defaults
None.
Mode
Interface configuration: C2
Example
This example shows how to enable RIP on the VLAN 1 interface:
C2(su)->router(Config)#interface vlan 1
C2(su)->router(Config-if(Vlan 1))#ip rip enable

distance

Use this command to configure the administrative distance for RIP routes. The no form of this
command resets RIP administrative distance to the default value of 120.
Syntax
distance weight
no distance [weight]
Parameters
weight
Defaults
None.
Mode
Router configuration: C2(su)‐>router(Config‐router)#
(su)‐>router(Config‐if(Vlan 1))#
Specifies an administrative distance for RIP routes. Valid values are 1 ‐ 255.
SecureStack C2 Configuration Guide 17-3
ip rip enable