Ip Bgp Neighbor Admin-State - Alcatel-Lucent 060321-10, Rev. B Cli Reference Manual

ip bgp neighbor admin-state

ip bgp neighbor admin-state
Enables or disables a BGP peer.
ip bgp neighbor ip_address admin-state {enable | disable}
Syntax Definitions
ip_address
enable
disable
Defaults
parameter
enable | disable
Platforms Supported
OmniSwitch 10K
Usage Guidelines
•
You must first create a peer and assign it an IP address using the
enabling the peer.
•
Configure all BGP peer related commands before enabling a peer using this command. Once you
enable the peer it will begin sending BGP connection and route advertisement messages.
Examples
-> ip bgp neighbor 172.22.2.115 admin-state enable
-> ip bgp neighbor 172.22.2.115 admin-state disable
Release History
Release 7.1.1; command was introduced.
Related Commands
ip bgp neighbor
show ip bgp neighbors
MIB Objects
alaBgpPeerTable
alaBgpPeerAddr
page 19-56
32-bit IP address of the new BGP peer.
Enables this peer.
Disables this peer.
default
disable
Creates a BGP peer.
Displays peer parameters.
ip bgp neighbor
OmniSwitch CLI Reference Guide
BGP Commands
command before
March 2011