Table of Contents
Advertisement
JunosE 11.3.x Link Layer Configuration Guide
Using ATM show Commands
show atm aal5 interface
72
Use the show commands described in this section to display information about your
ATM configuration and monitor ATM interfaces.
You can use the output filtering feature of the show command to include or exclude lines
of output based on a text string you specify. See section show Commands in JunosE
System Basics Configuration Guide.
Use to display information about a configured ATM AAL5 interface.
Field descriptions
AAL5 Interface operational status—Operational status of the AAL5 interface: up,
down, lowerlayerDown
time since last status change—Time since last reported change to the AAL5 interface
operational status
SNMP trap link-status—Whether SNMP link status traps are enabled or disabled on
the ATM AAL5 interface
Auto configure ATM 1483 status—Setting of the autoconfiguration feature for a
dynamic ATM 1483 subinterface configured over the ATM AAL5 interface:
enabled—Autodetection of the ATM 1483 dynamic encapsulation type is enabled
on the ATM AAL5 interface
disabled—Autodetection of the ATM 1483 dynamic encapsulation type is not
currently enabled on the ATM AAL5 interface
InPackets—Number of packets received on this interface
InBytes—Number of bytes received on this interface
OutPackets—Number of packets transmitted on this interface
OutBytes—Number of bytes transmitted on this interface
InErrors—Number of incoming errors received on this interface
OutErrors—Number of outgoing errors on this interface
InPacketDiscards—Number of incoming packets discarded on this interface
OutDiscards—Number of outgoing packets discarded on this interface
Example
host1#show atm aal5 interface atm 3/0
AAL5 Interface ATM 3/0 operational status:
time since last status change: 00:08:46
SNMP trap link-status: disabled
Auto configure ATM 1483 status: disabled
lowerLayerDown
Copyright © 2010, Juniper Networks, Inc.
Advertisement
Chapters
Table of Contents
Troubleshooting
