Ip Show Commands - Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - IP-IPV6-IGP CONFIGURATION GUIDE 2010-10-31 Configuration Manual

JunosE 11.3.x IP, IPv6, and IGP Configuration Guide
baseline tcp

IP show Commands

78
Use to set a statistics baseline for all (both IPv4 and IPv6) TCP statistics or for only
IPv4 or IPv6 statistics.
The router implements the baseline by reading and storing the statistics at the time
the baseline is set and then subtracting this baseline whenever baseline-relative
statistics are retrieved.
Use the ip keyword to implement a baseline for only IPv4 statistics.
Use the delta keyword with IP show commands to specify that baselined statistics
are to be shown.
Example 1
host1#baseline tcp
Example 2
host1#baseline ip tcp
There is no no version.
See baseline tcp
You can monitor the following aspects of IP using show ip commands:
To Display
Access lists
ARP
General IP information
IP addresses
Community lists
Routing table
Interfaces
Shared IP interfaces
Protocols
Redistribution policies
Command
"show access-list" on page 79
"show ip as-path-access-list" on page 83
"show arp" on page 80
"show ip" on page 80
"show ip address" on page 81
"show ip community-list" on page 84
"show ip forwarding-table slot" on page 84
show forwarding-table route-holddown in JunosE Command
Reference Guide
"show ip interface" on page 85
"show ip interface shares" on page 90
"show ip protocols" on page 93
"show ip redistribute" on page 96
Copyright © 2010, Juniper Networks, Inc.