Ipv6 Pim Dr-Priority - Juniper JUNOSE SOFTWARE 11.0.X - COMMAND REFERENCE A TO M 1-11-2010 Command Reference Manual

JUNOSe 11.0.x Command Reference Guide A to M

ipv6 pim dr-priority

ipv6 pim dr-priority priority
Syntax
no ipv6 pim dr-priority
Command introduced in JUNOSe Release 10.0.0.
Release Information
Assigns a priority for the interface to be selected as the designated router. An interface
Description
with a higher priority value is preferred as a designated router over an interface with
a lower priority value. In Interface Configuration mode, the no version restores the
value that is specified in Router Configuration mode. If the designated router priority
is not specified in Router Configuration mode, then the default value of one is restored.
NOTE: You cannot configure the designated router priority on PIM dense mode
interfaces.
Options
Interface Configuration, Router Configuration
Mode
1074
ipv6 pim dr-priority
priority Value in the range 1–254; default value is 1.