Xerox WorkCentre 5687 Series Service Manual page 463

B
• Perform OF7 IOT PWB Diagnostics RAP before a new IOT PWB is installed, PL
1.10 Item 2.
Enter dC330 code 10-030 inverter motor, MOT10-030. Press Start. The jam clearance knob,
2B, PL 10.15 Item 13, is stationary and the motor can be heard.
Y N
The jam clearance knob, 2B, PL 10.15 Item 13, rotates counterclockwise.
Y N
Go to Flag 4. Check MOT10-030. Refer to:
• GP 10 How to Check a Motor.
• P/J4, IOT PWB
• P/J45, P/J55
• 01G +24V Distribution RAP
• 01E +5V Distribution RAP.
• 01B 0V Distribution RAP.
Install new components as necessary:
• Inverter motor, PL 10.11 Item 11.
• Inverter motor driver PWB, PL 10.11 Item 22.
• Perform OF7 IOT PWB Diagnostics RAP before a new IOT PWB is installed,
PL 1.10 Item 2.
Install a new inverter motor driver PWB, PL 10.11 Item 22.
Check the following components, refer to GP 7:
• Idler roll, PL 10.12 Item 15.
• Upper baffle, (65-87ppm) PL 10.12 Item 22, (32-55ppm) PL 10.12 Item 23.
• Double exit nip rolls, PL 10.11 Item 8.
• Exit shaft assembly, PL 10.13 Item 4.
• Nip split shaft assembly, PL 10.11 Item 4.
• The drive gear on the fuser module, PL 10.10 Item 1.
• The fuser drive gear on the main drives module, PL 4.12 Item 10.
WorkCentre 5687 Family
Inverter nip solenoid
SOL10-050
Figure 1 Component location
August 2007
2-271
Inverter path solenoid
SOL10-045
Status Indicator RAPs
10-135, 10-136, 10-137, 10-138