Sheet Late To Hole Punch Rap - Xerox WorkCentre 5687 Series Service Manual

Figure 2 Circuit diagram
Status Indicator RAPs
11-100-110, 11-110-110

11-110-110 Sheet Late to Hole Punch RAP

11-110-110 Sheet late at the punch sensor.
Take care not to topple the LCSS.
The LCSS is unstable when un-docked from the machine.
Do not show the customer how to un-dock the LCSS.
Initial Actions
Check the following:
• The 2K LCSS PWB DIP switch settings, refer to 11F-110 2K LCSS PWB DIP Switch Set-
tings RAP.
• Ensure the paper tray guides are set to the correct position for the size of paper in the
tray.
• For a paper jam at the entrance to the 2K LCSS. Check that there is no obstruction that
would prevent a sheet from arriving in position for punching, refer to the 11H-110 Copy
Damage in the 2K LCSS RAP.
• The punch sensor, Q11-110 for chad debris, Figure 1.
Procedure
NOTE: In diagnostics, actuating any 2K LCSS sensor or switch can change the displayed state
on the UI. Make sure that the correct sensor or switch is tested.
Figure 1. Enter dC330, code 11-110. Actuate the punch sensor, Q11-110. The
changes.
Y N
Go to Flag 1 and check Q11-110.
Refer to:
• 11G-110 2K LCSS PWB Damage RAP.
• GP 11, How to Check a Sensor.
• P/J307, 2K LCSS PWB.
• 11D-110 2K LCSS Power Distribution RAP
Repair or install new components as necessary:
• Punch sensor, PL 11.6 Item 7.
• 2K LCSS PWB, PL 11.26 Item 1.
Perform SCP 6 Final Actions.
August 2007
2-306
WARNING
WorkCentre 5687 Family
display